2016–2019 Audi R8 Gen2 (Type 4S) Carbon Fiber Front Bumper Lip

Product specifications

Carbon Fiber Front Bumper Lip for 2016–2019 Audi R8 Gen2

Designed for selected 2016–2019 Audi R8 Gen2 (Type 4S) applications, this carbon fiber front bumper lip adds a more defined lower edge to the front of the R8 while following the wide, low proportions of the second-generation body design.

The gloss carbon fiber finish adds contrast beneath the factory front bumper and works well with other exterior carbon details without turning this single upgrade into a full body-kit conversion. For additional exterior parts for the same generation,

Vehicle Fitment

Vehicle: Audi R8 Gen2 / Type 4S
Model Years: Selected 2016–2019 applications
Engine: V10 applications based on current product fitment data
Body Style: Coupe / Spyder – confirm bumper compatibility before ordering
Generation: Pre-facelift configuration

Fitment depends on the original front bumper design and model-year configuration. Customers with vehicles near the facelift transition should compare the factory bumper shape carefully before ordering.

If your R8 uses the later facelift front bumper,

Gloss Carbon Fiber Finish

This Audi R8 Type 4S carbon fiber front bumper lip features an exposed carbon fiber weave with a gloss clear finish designed to complement the factory body lines and other carbon fiber exterior components.

The front lip follows the lower bumper profile to create a sharper front-end appearance while keeping the original R8 bumper and grille design visually recognizable.

Front-End Styling for the R8 Gen2

The second-generation Audi R8 features a wider grille, angular front intake sections and a lower overall nose profile. Adding a carbon fiber front lip emphasizes this lower bumper line and gives the front end a more finished, performance-inspired appearance.

This product is primarily an exterior styling upgrade. No specific downforce, handling, stability or fuel-economy improvement is claimed unless supported by product-specific testing.

Installation

Installation may use a combination of mounting screws and automotive-grade adhesive tape depending on the bumper and mounting position. Always test-fit the complete front lip before final installation and confirm that both sides and the center section align correctly with the factory bumper.

Professional installation is recommended if you are unsure about alignment, mounting preparation or the use of additional fasteners.